Better-BenchÈ is an easy to install bench-forming system that replaces the complex methods currently in use. This fully independent supporting unit can be mounted to most vertical surfaces quickly and efficiently, saving the installer valuable time. What once took days can now be done in about an hour!

Engineered 400 lb load capacity on the Better Tray.

All required fasteners are supplied.

Install before or after finish tile is applied to vertical surfaces.

Self-supporting, one piece frame is easy to install with supplied fasteners, requiring no additional waterproofing or structural reinforcement.

Use in wet or dry locations; mount over any U.B.C. approved substrate material.

Takes only minutes to mount, place mortar mix (sand & cement), and tile as desired.

Long lasting and corrosion resistant materials throughout.

Better-BenchÈ is manufactured in the U.S.A.

This product is produced of an alloyed aluminum and is sent as one piece. This is supplied with hollow wall anchors and wood screws. Fastening to studs, blocking, or other framing members is not required. If framing members are encountered, discard hollow wall anchor and use provided screw with an appropriate pilot hole.

Installation Instructions

All measurements are nominal unless other wise noted.

Sizing and shade variation from batch to batch are inherent in all clay fired material.